Attention must be paid to maintenance during operation, and ordinary maintenance can increase the service life of the equipment, save costs and create greater benefits. The following describes the precautions for the use of laser cleaning machine.
Today, when environmental protection is advocated, the laser cleaning machine has the characteristics of non-contact, no thermal effect and no mechanical force on the surface of the cleaned object. It is widely used in industry. What should be paid attention to when using the laser cleaning machine?
1.Follow the on-off sequence of the machine: firstly when starting up, turn on the water pump (water cooler);secondly power switch; thirdly the laser switch. When shutting down, first turn off the laser switch, then turn off the power switch, and then turn off the water pump (water cooler).
2.Clean the chiller of the laser machine regularly every half a month, drain the internal water of the machine, and then fill it with new purified water (the dirty water will affect the light output effect).
3.It is required to clean regularly and quantitatively every day, remove sundries on the table, stopper and guide rail, and spray lubricating oil on the guide rail.
4.The reflector and focusing lens shall be scrubbed with special cleaning solution every 6-8 hours. When scrubbing, it shall be scrubbed counterclockwise from the center to the edge of the focusing lens with a cotton swab or cotton stick dipped in the cleaning solution. At the same time, care shall be taken to prevent scratching the lens.
5.Cleaning method of exhaust fan and smoke pipe: when there is a large amount of smoke during processing, it is necessary to clean the fan, disassemble the outer cover of the fan, scrape the dust on the fan blade and air channel with a thin wooden sheet, and then blow the dust with a high-pressure gun. The cleaning method of smoke pipe is the same as that of exhaust fan water.
During the operation of the laser cleaning machine, a large amount of corrosive dust and smoke will be generated during the processing of the processed parts. These smoke and dust will be deposited on the surface of the guide rail and linear shaft for a long time, which will have a great impact on the processing accuracy of the equipment, and will form corrosion spots on the surface of the linear shaft of the guide rail and shorten the service life of the equipment. In order to make the machine work normally and stably and ensure the processing quality of products, the daily maintenance of guide rail and linear shaft should be done carefully.
